Engine Cover Fastener

Mod Details

PremiumNo Difficulty Mod ID1018 Creditevilution Cost££6+ For Linkhttps://www.evilution.co.uk/mod/engine-cover-fastener.htm Copy to Clipboard PartsBuy here

If you have owned a smart long enough, there is a good chance that at some point, the engine bay fastener will come loose. They pull out of the hole and eventually go missing after rolling into the engine bay somewhere.

If you haven’t lost the fastener, you can hold it back in place with a thin 5mm nylon washer which is what is fitted as standard. Alternatively you could fit a 6mm star retaining washer or a 5mm e-clip (c-clip, circlip).

However, the original engine bay fixings are rolled, not machined. They aren’t as smooth to operate and corrosion can make them stiff or notchy to twist, making it hard to properly close the engine bay cover.

Replace The Whole Thing

For the price, you may as well replace the fastener with a new one that is well made. Smartmods.co.uk sell machined fasteners made by the company that invented them, no crap copies.

What they sell is the official 17mm Dzus Panex fixing kit as seen below.

The price has now been reduced and the right hand square receiver clip is no longer supplied. Most people said they didn’t need it as the original receiver was still in place and worked fine.

Lever out the old retainer. The old one won’t be as springy as the replacement.

Slide the new receiver into position. (no longer supplied).

Put the new quarter turn fastener into the hole of the engine bay lid…

…and then push the nylon washer onto the back to hold it in place.

The quarter turn fastener is now correctly set in place and ready to hold the engine bay lid down.

I recommend a little copper grease on the stem of the fastener to keep the action smooth.